Title: How to Open a Long Arm Stapler for Reload: A Step-by-Step Guide
Are you tired of struggling with a stubborn long arm stapler that refuses to open for reloading? Relax, you’re not alone! Many office workers and DIY enthusiasts face this frustrating issue. In this article, we’ll walk you through a simple, step-by-step process to open your long arm stapler and get it ready for a fresh cartridge.
Understanding the Long Arm Stapler Mechanics
Before we dive into the solution, it’s essential to understand the basic design of a long arm stapler. These office tools feature a spring-loaded mechanism that holds the stapling head in place, keeping it closed until you’re ready to use it. When you want to reload, you need to open the stapling head to release the old staples and insert a new strip.
Step-by-Step Instructions to Open Your Long Arm Stapler
- Gently lift the stapling head: Use your fingers to lift the stapling head by placing them under the flat plate on top of the stapler, near the staple tray. Be gentle, as excessive force may cause damage to the mechanism.
- Press the release button: Locate the release button, usually located on the side or top of the stapler. Press it down firmly with your thumb or index finger to release the tension in the spring. You might need to use a bit of force, but be careful not to push too hard, which can cause the stapler to jam.
- Slide the stapling head: With the release button still pressed, slowly slide the stapling head away from the staple tray. This should allow the spring-loaded mechanism to fully open, giving you access to the staple tray.
- Remove old staples: Carefully remove the old staples from the staple tray, making sure to pull them out straight and not bent. Don’t touch the staple wire, as this can cause the tips to become dulled.
- Insert new staples: Place the new staple strip into the staple tray, making sure to align it with the notch on the tray. Gently push the strip into the tray until it clicks into place.
- Replace the stapling head: Slide the stapling head back over the staple tray, ensuring it’s securely in place.
- Release tension: Let go of the release button, and the spring-loaded mechanism will return to its normal position. Your long arm stapler is now ready for use again.
Tips and Precautions
- Always handle the stapling head with care to avoid damaging the mechanism.
- When reloading, make sure to remove all old staples to prevent jams and misfires.
- If you encounter resistance or difficulty opening the stapling head, it might be due to old or bent staples, which can be removed and replaced with new ones.
- Regularly clean and maintain your long arm stapler to avoid sticky or clogged mechanisms.
By following these simple steps, you should be able to open and reload your long arm stapler with ease. Remember to handle the mechanism with care and take your time to avoid any damage. Happy stapling!
I've tried evrything now. It's a Rapesco 790. No instructions on the internet. I think the little section at the bottom slides out for reloading but it won't go.